Owner Group Usage: lonepeak
The following constraint utilization information can be used to (possibly) minimize
the chance of preemption when running guest jobs. Note, however, that the past usage
of a group does not indicate their future behavior; preemption is still possible when
using the results presented here. Also, the available cores and memory on each node
may differ, so check that you are using valid constraints that will allow the job
to run. The sinfo
aliases si
and si2
(documented on the Slurm page) can be used to determine the number of cores and total memory on each node and multiple
constraints can be specified by using logical operators. This same technique can be
used to specify multiple groups (nodes with some constraint or another). For more information, see the introduction on the index page.